THUNDER LASER
MARS-120
www.thunderlaser.com
THUNDERLASER TECH CO., LTD
tech@thunderlaser.com
Tel :(86)755 82689501
20
3.3 Location
Before you install the laser system, you should select an appropriate location. Follow the
guidelines shown below:
1.
Avoid locations where the system is exposed to high temperatures, dust and high
humidity. (The humidity must not exceed 70% and the temperature must not be close
to the dew point.)
2.
Avoid locations, where the system is exposed to mechanical shocks.
1.
Fuse protection:
Do not connect other devices via the laser fuse, as the laser system requires the full
amperage.
Tips
:
1. Avoid locations with poor air circulation.
2. Select a location, whose room temperature is between 15 °C and 25 °C (59°
– 77° F).
Avoid higher ambient temperatures and strong exposure of the engraver to the sun.
Use blinds, if required.
3. Select a location close to ventilation (if available).
4. Select a location that is not more than 4.50 m away from your computer (max. cable
length to avoid disturbing interferences).
5. Try to place a working table or a place to put things next to it. This shall avoid, that the
machine is misused as a table.
