THUNDER LASER
MARS-120
www.thunderlaser.com
THUNDERLASER TECH CO., LTD
tech@thunderlaser.com
Tel :(86)755 82689501
28
1. Top lid 12. PC connection port(USB)
2. Left-up side door 13. U-disk connection port(USB)
3. Left side door 14. Main power switch
4. Autofocus sensor 15. Laser power switch
5. Laser head 16. Connection Socket for Rotary
6. X-axis 17. Water in and water out
7. Y-axis 18. Rear door
8. Working table 19. Manufacturer
’s label
9. The display 20. Power supply socket
10. Right-up side door 21. Laser tube cover
11. Right side door 22. Exhaust hose
1. Top lid
If the Top lid is opened, no data is processed. When the protection cover is opened
during working, the motion system is stopped and the laser source is turned off.
During processing of commands the protection cover must only be opened after
pressing the
“Pause “button.
2. Left-up Side Door
Open this door for cleaning the second reflective mirror
3. Left Side Door
There is laser power supplier, air pump and red dot pointer power supply interface
here, please open this door for checking these parts, but must pay attention to the
electric current.
4. Autofocus sensor(optional)
Used for the automatic focusing of the work table.
5. Laser head
The laser and red dot pointer comes out from the laser head, and the Auto Focus
switch is installed on the laser head, too. The bottom of laser head is parallel to the
bottom of the autofocus switch.
6. X-axis
The motion system is that performs the mechanical movements in X direction. The
X-axis is visible in the working area.
7. Y-axis
The motion system is that performs the mechanical movements in Y direction. The
Y-axis is visible in the working area.
8. Working Table
The honey comb plate to be processed is put onto the working table. Put the material
on the working table for engraving & cutting
