THUNDER LASER
MARS-160
www.thunderlaser.com
DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com
Tel :(86)769 82665376
35
4.3 How to use the TL-Timer
The TL-Timer is an additional tool for laser machines.
It will control laser machines periphery like exhaust fan, air-values, warning lights,
pneumatic lifts, electrical locks and lost of other stuff automatically.
This will increase the ease of use of your laser machine.
Please note the different types of connection, which makes the TL-Timer able to work with
each kind of laser controller.
Operation:
Normal use:
The TL-Timer gets activated by a control signal from laser controller. For this case the red
LED lights up and all 4 relays will be activated until the signal from controller gets turned
off. Without control signal the 4 relays will stay turned on until a given delay time has
expired. Each relay has a freely adjustable delay time from 1-300 seconds.
Set up delay time:
Enter “Menu” switch once. The red LED will blink and the display will show you the delay
time in second for the first relay. A yellow LED close to the active relay will show you.
Which one is active.
The display does show the delay time in seconds. By pr
essing “down” or “up” you can
change the value. By holding a switch down for more than 2 seconds the value will
increase or decrease automatically.
By pressing “Menu” you can switch to relay number 2 now and set the delay time for this
one.
For changing delay values for 3
rd
and 4
rd
relay you have to press “Menu” again.
When 4
th
relay is active and you press “Menu” again. The TL-Timer will turn back to
normal operating mode; the red LED will stop blinking.
After turning of power the TL-Timer will remember the delay-time-values, you did enter
before.
Relay-Output:
Each of the 4 relays offers a opening and closing switch with current capacity of max.
8Amps and a power capacity of max. 1000W.
Higher loads must be controlled by using a power contactor.
