THUNDER LASER
MARS-160
www.thunderlaser.com
DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com
Tel :(86)769 82665376
53
4.6.20 File Key
1). Memory File
On the main interface, if
“File” key is pressed, it will show as below:
File
：
Speed
：
MaxPow
：
01
300mm/s
30.0%/30.0%
X
：
Y
：
Z
：
150.2
153.5
3000
mm
mm
mm
01 400
02 200
03 100
File
：
Count
：
Udisk+
Other+
Run
Track
Work time
Clear count
Delete
Copy to udisk
Read mem file
Idle 00.00.00 Count: 99 X: 180.5 mm Y: 235.6 mm connect
When showing this menu, the system would read the memory file firstly, the file name and
the work times would be listed in the area, and the selected file is previewed in the bottom
right area.
“Y+/-” keys could be used to move the cursor on the file name list. When the
cursor is on a target file name, presses the
“Enter” key, the selected file will be previewed
on the main interface, and then if
“Esc” key is pushed, the preview will disappear.
“X+/-” keys could be used to move the cursor left and right. All the item show as below:
Read mem file
: read the memory file list;
Udisk
: read the U disk file list;
Other
: the other operation of the memory files;
Run
: To run the selected file;
Track
: To track the selected file, and the track mode is optional;
Work time
: To forecast the running time of the selected file, and the time is
accurate to 1ms;
Clear count
: To clear the running times of the selected file;
Delete
: To delete the selected file in the memory;
Copy to Udisk
: To copy the selected file to Udisk;
If the
“Other” entry is pressed, the system will show as below:
