THUNDER LASER
MARS-160
www.thunderlaser.com
DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com
Tel :(86)769 82665376
6
1.2
Designated
The THUNDER LASER MARS-160 is used for engraving and cutting of signs, stamps
and suchlike.
A wide variety of materials such as rubber, acrylic, coated metal, tin, special steel,
anodized aluminum, cork, cardboard, glass, leather, marble, several plastics and wood
can be processed on the laser.
1.
The engraving process must only be performed with a perfectly adjusted machine.
2.
For cutting applications with 100 W the use of the cutting table is absolutely necessary.
3.
Use of the system in other areas is against the designated use. The manufacturer does
not admit liability for damage to personal and/or equipment resulting from such use.
4,
The system must only be operated, maintained and repaired, by personnel that are
familiar with the designated field of use and the dangers of the machine!
5.
Non-observance of the instructions for operation, maintenance and repair described in
this Operation Manual excludes any liability of the manufacturer if a defect occurs.
6.
Caution when processing conductive materials (carbon fibers), Conductive dust or
particles in the ambient air might damage electrical components and lead to short circuits.
Bear in mind that those defects are not warranted.
1.3
Disposal remarks
Do not dispose the machine with domestic waste!
Electronic devices have to be disposed according to the regional directives on electronic
and electric waste disposal. In case of further questions, please ask your supplier. He
might take care of proper disposal.
