USERS MANUAL NOVA SERIES
DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653
Dongguan City, Guangdong Province, China
11
11
Chapter 2. Safety
2.1 General Safety Information
All personnel involved in installation, set-up, operation maintenance and repair of the
machine, must have read and understood the Operation Manual and in particular the
"Safety" section. The user is recommended to generate company-internal instructions
considering the professional qualifications of the personnel employed in each case, and
the receipt of the instruction/Operation Manual or the participation at introduction/training
should be acknowledged in writing in each case.
Safety-conscious of Working
The machine must only be operated by trained and authorized personnel.
The scopes of competence for the different activities in the scope of operating the
machine must be clearly defined and observed, so that under the aspect of safety no
unclear questions of competence occur. This applies in particular to activities on the
electric equipment, which must only be performed by special experts.
For all activities concerning installation, set-up, start-up, operation, modifications of
conditions and methods of operation, maintenance, inspection and repair, the switch-off
procedures that may be provided in the Operation Manual must be observed.
Safety Information for the User and/or Operating Personnel
1. No working methods are permitted that affect the safety of the
machine.
2. The operator must also ensure that no unauthorized persons work with
the machine (e.g. by activating equipment without authorization).
3. It is the duty of the operator, to check the machine before start of work
for externally visible damage and defects, and to immediately report
changes that appear (including behavior during operation) that affect
the safety.
4. The user must provide that the machine is only operated in perfect
condition.
5. The user must guarantee the cleanness and accessibility at and
around the machine by corresponding instructions and controls.
6. No safety components may be removed or disabled (again we
emphasize the imminent dangers, for example severe burns, loss of
eyesight
, etc…). If the removal of safety components is required during
repair and service, the replacement of the safety components must be
performed immediately after completion of the service and repair
