USERS MANUAL NOVA SERIES
DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653
Dongguan City, Guangdong Province, China
17
17
3.2 Location
Before you install the laser system, you should select an appropriate location. Follow the
guidelines shown below:
1. Avoid locations where the system is exposed to high temperatures,
dust and high humidity. (The humidity must not exceed 70% and the
temperature must not be close to the dew point.)
2. Avoid locations, where the system is exposed to mechanical shocks.
1. Circuit Breaker protection: Do not connect other devices on the same
circuit as the laser system. It requires a dedicated circuit.
2. DO NOT open any of the machine’s access panels while the unit is
plugged in. Opening a panel may expose the operator to severe
electric shock, invisible CO2 laser radiation, mechanical pinch points,
burns, blindness, and other hazards. ALWAYS POWER OFF AND
UNPLUG!
3. DO NOT make or break any electrical connections to the system
while the unit is turned on.
1. Avoid locations with poor air circulation; select a location close to
ventilation (if available).Select a location, whose room temperature is
between 15 °C and 25 °C (59°
– 77° F).
2. This is fundamental to maintain consistent and reliable operation of a
CO2 laser, Metal RF or Glass tube and the machine itself. Avoid higher
ambient temperatures and strong exposure of the engraver to the sun.
Use blinds, if required.
3. Mechanical shock and vibration of the laser will have detrimental
effects on the performance and life expectancy of the machine. It will
manifest (over a period of time) with a noticeable decrease in
performance and increased maintenance required, possibly even
damage. Setting your Thunder Laser up in s suitable temperature
controlled, dust free, moisture free, level, stable surface (a level
concrete floor) with the recommended extraction is critical to the
ongoing performance of the machine. It is also a warranty condition.
