4
ASSEMBLY / WING
4. Note the orientation of servo output shaft and
install aileron servo on the wing first. Do not glue
the wing before you install the aileron servo. Next
connect the servo wire to RX and turn on radio to
make sure the servo rotating direction is correct.
Secure the ser vo horn with the screw which
comes with the servo. Now you can center and
epoxy the main wing in place. Reinforce wing with
triangle Balsa wood. Note the servo wire should
go right side as RX and ESC will be installed at
right side of fuselage later.
5. For Christen Eagle owner
Locate wing support and epoxy the wing support and
upper wing in place as shown.
It will be easier if you place the airplane up side down
to apply epoxy at the joints.
1. Check all pre-hinged aileron and elevator, lightly
press the taped area and make sure the aileron
and elevator will not come apart. You will also
have to check this before and after each flight to
get precise throws for better performance.
2. Cut triangle balsa wood as indicated length which
is going to reinforce the main wing later and keep
the rest wood for elevator.
Expo 3D: 13.5cm; 6.5cm (5-1/4”, 2-1/2”)
G202: 13cm; 8cm (5-1/8”, 3-1/8”)
Christen Eagle: Lower Wing–1cm;9.5cm (3/8”, 3-3/4”)
Upper Wing– 11cm (4-1/4”)
3. Get the fur nished ser vo tape 3/16"x 1/2"
(5x12mm) and place as shown.
ASSEMBLY
Expo 3D
G202
Christen Eagle
