31. Trim the tail fuselage as shown to make sure the tail
pitch control rod is work smoothly.
32. You may need to install the remote glow plug
extension wire (No.AT6078) for easy igniting as well as
the precision fueler valve (No.1115) for easy fueling.
33. Install a diverter (No.1114 or 1114-Y) and drill an
exit hole at the bottom of the fuselage as shown. You
may extend the diverter to fuselage exhaust pipe to
obtain a more scale-like look.
34. Use the tempalate drawing as shown in page13,
then trim the tail end as shown.
35. You may wisely to use mask tape to tape it in place
then make marks. Drill 1.5mm
(1/16”)
pilot holes on each mark
then secure the tail in place with eight 2x5mm wood
screws.
36. Use the same way to install the top fuselage with 12
pieces of 2x5mm wood screws.
37. Trail fit the front fuselage to the rear fuselage.
Decide ten mounting holes then make marks on the
fuselage. Drill 1.5mm(1/16”) pilot holes. Secure the
front fuselage in place with ten 2x5mm wood screws.
38. Cut the foot step in length of 50mm(1-7/8”).
Assemble the whole foot step as shown, note the
orientation of the step support and remember to glue
the end cap with CA instant glue
4
2
m
m
(1
-5
/8
”)
30mm(1-3/16”)
13
12
39. Make marks on fuselage where foot step assembly
going to install. Drill 2mm(5/64”) holes at the marks
then secure the foot step assembly with the collar.
Apply tiny CA on the collar to prevent it from loose.
Apply black strip on the landing skid and foot step as
shown.
42mm
3
0
m
m
