-33-
HELI ACCESSORIES /
選購配件
or
或者
A
B
B
A
B
A
new C.G
new C.G
Lighter Blade (Mark A)
較輕的槳做上記號A
Heavier Blade (Mark B)
較重的槳做上記號B
A
A
B
B
Step 1 /
步驟一
Mark C.G position of
A and B blades
在A跟B旋翼上做重心的記號
Step 2 /
步驟二
Mark new C.G position on A blade
(Same position with B blade)
在A旋翼上標示新重心記號
(與B重心相同位置)
B
B
A
A
Blade Balancer
主旋翼平衡器
STORAGE
攜帶與收藏
RECOMMENDED BALANCING PROCESS
平衡執行流程
The Seesaw Bridge can be put inside the base for
easy storage.
蹺蹺板可以卸下並收藏於基座內
The following is the recommended balancing process
to correct the position of the C.G. as well as balancing
the weight of the blades.
請參考以下流程修正主旋翼重心位置,同時針對旋翼重量
進行平衡。
1. Please do the “Static Balance” first and find out
which blade is lighter than the other. The lighter
blade is supposed to be the object to be adjusted.
(Mark A)
請執行靜平衡量測,並選取較輕的旋翼作為調整對象
(做上記號A)。
2. Proceed with the “Dynamic Balance” and check
the C.G. position of both blades. Adjust the C.G.
position of the lighter blade(A) as illustration.
Make sure the C.G. position of the lighter blade is
the same as the heavier one.
針對較輕的旋翼(A)進行重心位置調整,目的在使兩
旋翼的重心位於相同位置。
Item No. / 料號:1077
or 或
3. After adjusting the C.G., please do the “Static
Balance” again. It is recommended to use the
sticker on the new C.G. position of the lighter blade.
Please note that the C.G. position won’t be
changed after static balance.
再度進行旋翼的靜平衡重量調整,目的在使兩旋翼的
重量相同。請注意配重貼紙必須貼在新的重心位置上,
避免重心位置再度改變。
Sticker on new C.G positioni
配重貼紙必須貼在重心位置
Lighter Blade
較輕的槳
or
或
new C.G
A blade
C.G
B blade
NOTE /
注意事項
Please note how to use the sticker to balance
the blade. It may be easily lifted off if you
don’t tape it correctly as illustrated.
請注意配重貼紙的使用方式,若配重貼紙的貼法
錯誤,將很容易在飛行中被撕離旋翼表面。
wind
風向
wind
風向
wind
風向
Move C.G to inner side
貼上配重貼紙於內側,將
重心往右側移
Move C.G to outer side
貼上配重貼紙於外側,
將重心往左側移
Step 3 /
步驟三
Change C.G to new
postion by sticker
使用配重貼紙將旋翼重心移
至新位置
(與B重心相同位置)