19.Insert the wheel strut assembly in the wheel
slider, do the same way at the other side.
20.Insert the landing gear in the fuselage then
Push-N-Lock
the landing gear retainer.
21.Locate the control horn and locking plate
then
Push-N-Lock
the control horn in
place as shown. Note: Do not push too hard
but gently all the way in so the control horn
contacts the surface of rudder at both sides
and secured in place firmly.
22.Trial fit the joiner in place next apply epoxy
and glue it firmly in place. It will be easier
to bend two elevators then slide the joiner
on the elevator.
23.Epoxy the horizontal tail and vertical tail as
shown, and use square guide to make sure
they are perpendicular to each other.
24.First snap the clevis onto elevator joiner,
next epoxy the horizontal tail and vertical
tail in fuselage, make sure they are per-
pendicular to each other. After it cured,
snap the other clevis onto rudder control
horn.
ASSEMBLY/TAILS