25.Install the power drive unit in place with two
3 x20mm wood screws. Thread the motor
wire through the firewall.
26.Install the eyelet and grommet then secure
the micro servos in the servo tray with the
wood screws that comes with the servo,
connect the servo wire to the receiver and
turn on radio then thread the pushrods to the
servo horn and secure the servo horn on the
servo when servo is in neutral position.
27.Install the switch of the electric speed
controller. Do not over tighten the screw as
it may crush the Styrofoam.
28.Use double sided tape to fix the ESC and
Receiver inside the fuselage. Connect all
servo wires and controller wire. Normally
the controller wire plug into the channel 3
(throttle). The servo wires plug into channel
1(Rudder) and channel 2(Elevator).
29.Locate the sponge then cut a small piece to
keep battery in case firmly. Usually we put the
sponge facing the tail as shown.
30.You will have to bow the cover plate to close
or pry with finger to remove the cover plate.
Note: the opening is facing to the tail.
SERVO,ESC,RX & BATTERY INSTALLATION
