7
WING ASSEMBLY
❐
Install control horns. Use a pen or marker to mark the positions for
the aileron control horn.
❐
Drill out the holes as shown. Attach the control horn using the
enclosed bolts and control horn back plate.
❐
Attach the Z-bend end of the control rod to the servo horn, then
attach the clevis to the threaded end and bolt it to the control horn. It
may be necessary to enlarge the hole in the control arm to allow the
Z-bend to fit.
III. Join Wing Panels
❐
Locate the four dihedral braces and stack them, then mark an arrow
indicating the 'up' edge. Trial fit the braces in each wing panel. If
needed, sand the edges lightly so that the brace fits in each wing
smoothly.
❐
Mix some 5 minute epoxy and laminate the four dihedral braces
together and clamp for 30 minutes.
❐
Mix up some more 5 minute epoxy and glue the dihedral brace into
one of the wings and let it dry for 30 minutes.
❐
Mix up an ample amount of 30 minute epoxy and apply to the inner
ribs on each wing panel and dihedral brace and make sure you have
plenty inside the wing joiner slot. Slide the wings together, tape
around the joint, and wipe off any excess epoxy. Set aside for 1 hour.
Note: The pushrod is 2.3mm(0.09"), you have
to locate the right clevis which has bigger hole
for pushrod to thread in.
