THUNDER TIGER ZT2, Instruction Manual

4

PREPARING THE RADIO

a. Install the antenna into transmitter 

b. Check the frequency printed on the transmitter crystal.

c. Check the frequency printed on the RS ESC/Receiver module and crystal. Make sure it matches 

with the transmitter crystal. Make sure no one will operate on the same frequency when you are.
When there is a radio glitch, it will most likely be caused by improper crystal, damaged crystal, or
people operating on the same frequency.

1

a

a

b

b

c

c

BATTERY INSTALLATION

a. Install 8 AA size alkaline batteries into the transmitter.

b. Install supplied power pack into the batter holder. And then secure the battery holder under the

battery cover plate and RS ESC/Receiver module by using a small "R" clip.

c. Connect the plug harness of the battery with the RS ESC/Receiver module.

2

a

a

b

b

c

c

RADIO OPERATION

a When turning radio on, first turn on the transmitter.

b. Then, turn on the receiver. When turning off, first turn the receiver off, then the transmitter off. It's

an important hint to prevent unexpected damages.

c. To reverse the functions of servos, use the small, white servo reverse switches located on side of

the pistol transmitter. To trim the servos on pistol transmitter, use the trim switches on side of the
steering wheel (the ST. trims steering, and the TH trims throttle/brake). 

d.Do not run flat the battery of your transmitter in case of losing control of the car.

3

a

a

b

b

c

c