1
Table of Contents PAGE
DESCRIPTIONS OF EQUIPMENT AND OPERATION
Sport Timer 3000 Controller/Timing Computer
2
Infrared (IR) Beam Transmitter
3
Infrared (IR) Beam Receiver
3
Beam Alignment (ALWAYS do this for best results)
4
Big Display Scoreboards
4
Wireless Data Interface to Windows PC
5
LOW battery warnings
5
BASIC TIMING SETUPS
Manual Stopwatch
6
Single IR Beam at Finish Line, manual Start
6
Single IR Beam at Start Line, manual Finish
6
Single IR Beam at the Same Start/Finish line
7
Dual IR Beams at Separate Start and Finish lines
7
Multiple IR Beams for segment timing
7
Using Deadtime to disable Beams
7
Review times stored in memory
7
CONFIGURATION MENUS
8
Cloc Set Timer to count UP or DOWN
9
PAS Set Timer reset to zero, or resume on Start
9
Sond Set LOUD Beep Signal at Start and Stop
9
StEP Set speed of pre-setting times
10
Circ Enable Circuit Training Program
10
LAP Enable LAP Timing
10
SPLi Enable SPLIT Timing
11
ScLc Set rest period for Circuit Training Program
11
Strt
Set START Deadtime
11
StoP Set STOP Deadtime
11
For
Set data format for Wireless PC Interface
12
bAtt Display Sport Timer Battery Voltage
12
dFLt Reset to Factory Default Settings
12
TESt Wireless TEST mode
12
SPECIFICATIONS
13
APPENDIX 1 – Timing 101 – Typical Settings
14
APPENDIX 2 - Wireless PC Interface Manual
18
