Atlas IP+ Terminal User Manual
Page 4 of 106
SAFETY INSTRUCTIONS
For the sake of safety and protection, read the manual before attempting to use Thuraya Atlas
IP+ Terminal.
The following general safety precautions must be observed during all phases of operation,
service and repair of this equipment. Failure to comply with these precautions or with specific
warnings elsewhere in this user guide violates safety standards of intended use of the
terminal.
Addvalue Innovation Pte Ltd assumes no liability for the customer's failure to comply with
these requirements
.
Hazard Symbols
Antenna Radiation Warning
and Distance to other
Radiation Equipment
For safety reasons, all personnel and other radiating
devices must be kept at least 100cm from the ADU.
Power Supply
Turn off the power at the mains switchboard before
beginning of the installation.
Confirm the power voltage is compatible with voltage
rating of the equipment. It is highly recommended to use
+24V DC power line, provided that it is available on the
vessel.
In case of unavailability of +24V DC power line provided
by the vessel, an external AC/DC power supply of
115/230V AC with its output of +24V DC can be used.
Note:
The requirements of the AC/DC power supply
should take care of
high surge current of 25A at 24V
DC for 1ms.
