Atlas IP+ Terminal User Manual
Page 69 of 106
7 USING ALERT BUTTON
An Alert Button is easily to be found on the top, right bottom of the BDU and it is used for
triggering an emergency alert.
Before using the Alert Button, the pre-configuration in both Data and Voice Modes is to be
set up under the tracking page. On the Web Console, select
Settings
and then click
Tracking
. (Refer to Settings Menu and look for Tracking on the settings)
Once the pre-configuration is set up, the Alert Button function is ready to use.
Lift up the Alert Button cover, press and hold it for at least 4 seconds. The Alert Button will
then be illuminated to indicate that it is active. Additionally, the alert icon will be blinking on
the Web C
onsole’s indicator.
The pre-defined message appended with the GPS location will be sent out in the following
modes:
In
Voice
Mode, the message will be sent via SMS.
In
Data
Mode, the message will be sent via IP Data
*
.
Note:
Alert button via Data Mode requires the subscription of Backend Tracking Service. Without the
backend server and leaving the backend server IP address empty, the illuminated Alert Button
will
disable after 5 seconds
.
Note that by pressing the button again, it will not disable the alarm. Click
Turn Off Alarm
button on the webconsole to stop the alarm.
