151
NC20 - Manual - 01 - 2015
SETTING AND COMMISSIONING
7 P R O G R A M M I N G A N D S E T T I N G S
7 P R O G R A M M I N G A N D S E T T I N G S
All relay programming and adjustment operations may be performed through MMI (keyboard and
display) or using a Personal Computer with the aid of the ThySetter software.
7.1 SW
ThySetter
The ThySetter sw is a “browser” of data (setting, measure, etc..); it implements an engine that is
afford to rebuild the menu set up and the relationships to data concerning all Thytronic protective
relays by means of XML fi les.
ThySetter installation
The latest release of ThySetter can be downloaded free of charge from the
(Products - Software).
[1]
ThySetter use
Please refer to ThySetter user manual for detailed instructions.
The document is available on
(Product / Sotware / ThySetter - Download area).
Note 1 Starting from the 3.5.9 release it is necessary to download and install not only the application setup but the Template setup also. In case off
updating download and install only the new release.
WARNING
For safety reasons, a change of the following parameters become active only after an hw reset:
- Relay nominal frequency (
f
n
) and phase nominal voltages (
U
n
)
- Ethernet communication parameters (IP host address, IP net mask, Autonegotiation).
WARNING
For safety reasons, a change of the following parameters become active only after an hw reset:
- Relay nominal frequency (
f
n
) and phase nominal voltages (
U
n
)
- Ethernet communication parameters (IP host address, IP net mask, Autonegotiation).
