12
Setting up your TI-Navigator™ network the first
time
A Network Setup wizard helps you connect the TI-Navigator™ parts in
the correct order, activate the access point and hubs for wireless
communication, and register the TI-Navigator™ product.
Before you begin
1.
Make sure you have installed the TI-Navigator™ software on your
computer.
2.
Make sure the access point is
not yet
plugged in to a power outlet. If
you are using the USB-to-Ethernet adapter, make sure it is
not yet
connected to the computer’s USB port.
3.
Make sure each hub is fully charged ( LED is solid green).
4.
Remove the hubs from the charging bay. Each hub must have a
network connector attached.
The LED changes from solid green to blinking green when you
remove a hub from the charging bay.
5.
Have a ball-point pen or paper clip handy; you’ll need it to reset the
hubs.
Note:
If you see a Digital Signature Not Found message while setting up
your network, click
Yes
to continue. The message does not mean there is
a problem.
InstallationGuide.book Page 12 Wednesday, May 3, 2006 10:19 AM