52
Cannot add the
access point to
the network
•
The network adapter may be improperly
configured. Click
Start > Programs > TI Tools
> TI-Navigator > Network Manager
, and
then click
Actions > Configure Network
Adapter
.
•
Confirm that the network adapter is
connected to the access point using the
supplied crossover cable, not a standard
Category 5 Ethernet cable.
•
The access point is not in a receptive state. If
its configuration has been corrupted, reset
the access point to the original settings. You
will need to reconfigure the access point and
add all the hubs to the network again. (See
“Resetting the Type 2 access point” on
page 56.)
•
The software may be blocked by filters. Some
firewall and virtual private network software
prevent Network Manager from getting
access to the ports required for configuration.
Have the system administrator verify that
other programs or drivers are not blocking
access to the network adapter.
•
If you have activated Internet Connection
Firewall or Internet Connection Sharing on
your system, disable these features.
Device is
incorrectly
configured
This hub has been
located, but one
or more
configuration
parameters are
set incorrectly.
•
Repeat the Add Hubs procedure to
reconfigure this hub. (See “Activating Type 2
network hubs” on page 27.) or (See
“Activating Type 1 network hubs” on
page 31.)
•
Remove the hub and then add it back into the
network.
Problem or
message
Possible causes or solutions
InstallationGuide.book Page 52 Wednesday, May 3, 2006 10:19 AM