MODEL 1601 SERIES COFFEE BREWER
COMPONENT MAINTENANCE MANUAL
WITH ILLUSTRATED PARTS LIST
25-30-27
Page 301
September 1, 2005
DISASSEMBLY
1. General
A. Since complete disassembly is impractical and undesirable, only the following items
should be removed as required: Those which have been definitely established by
Check and/or Fault Isolation procedures as being defective, those which must be
removed to gain access to remove a defective part, and those which must be
removed in order to electrically isolate a part suspected of being faulty. Check
testing and Fault Isolation procedures determine those components which are
defective and, therefore, the extent of disassembly required.
B. This section consists of the following subsections:
a.
Disassembly instructions for Model 1601
b.
Disassembly instructions for Models 1601A and 1601B
NOTE:
Observe proper ESD handling and storage procedures for PCB assemblies
after removing top cover. ESD Discharges may damage PCB assemblies.
2. Disassembly Instructions for Model 1601
A. Top Cover and Cold Water Tray Disassembly (Figure 1001)
1. Remove top cover (10) by removing screws (35).
2. Remove gasket (30) and cold water tray (25).
3. If required, remove receptacle (15) from top cover (10) by removing screws
(20).
B. Water Tank Disassembly (Figure 1001)
1. Remove brew tube (255) from barbed adapter (45). Pull brew tubing (255)
through the tank assembly (355). Remove tank washer (365).
2. Disconnect tubes (255) from heater casting (100).
3. Note correct orientation for later installation, and remove check valve (250)
from tubing (255).
4. Remove silicon tubing (200) from fitting (205).