Bond 2
User Manual
Page 27 / 30
6. Line In mode
6.1. Line in mode setup
•
Whilst the Bond 2 is turned off, connect a 3.5mm
jack cable to the “Line in” port at the rear of the
unit and the other end of the cable to your source.
This is to avoid speaker pop when the Bond 2 is
turned on.
•
Hold the power/pre-set button to turn on. If
performed correctly, the Bond will respond by
saying “Power on.” The unit will then tell you what
mode is currently activated. E.g. Wi-Fi mode.
•
Press the mode button until the unit responds
saying “Line In mode.” The mode light will also
turn green.
•
You can now play music to the Bond via your source.
Summary of Contents for Bond 2
Page 1: ...Bond 2 User Manual...