17
Turn it back on
BASIC OPERATIONS
BASIC OPERATION 1
1. Press the Power On/Off button on the front panel to
switch on the unit.
2. Select the desired source by pushing the cor-
responding button.
-
BD/DVD (ANA, COAX, HDMI)
-
VIDEO 1 (ANA, COAX, HDMI)
-
VIDEO 2 (ANA, OPT, HDMI)
-
TUNER (FREQUENCY)
-
LINE IN
STEREO DIRECT
BLUETOOTH
-
-
-
AUX/ REC (ANA, OPT)
-
If
appears on the display: A digital input
source (OPT or COAX or HDMI) has been se-
lected, and the source is connected successfully.
-
If “UNLOCK” appeared for 5 seconds on the
display: The source is not connected properly or the
source is not switched on.
In that case, connect and switch the source on, or
select ANALOG by pressing the INPUT MODE button.
Play the source, and gradually turn up the volume to
the required level with the MASTER VOLUME control.
BASIC OPERATION 2
STEREO
With the unit in the STEREO mode, only Front Left,
Front Right Speaker and Woofer will have output.
Dolby Pro Logic II
Dolby Pro Logic II is a new multi-channel playback for-
mat developed by Dolby Laboratories using feedback
logic steering technology and offering improvements
over conventional Dolby Pro Logic circuits.
Dolby Pro Logic II can be used to decode not only
sources recorded in Dolby Surround but also regular
center, surround left and surround right) to achieve
surround sound.
Whereas with conventional Dolby Pro Logic the sur-
round channel playback frequency band was limited,
Dolby Pro Logic II offers a wider band range (20 Hz to
20 kHz or greater). In addition, the surround channels
were monaural (the surround left and right channels
were the same) with previous Dolby Pro Logic, but
Dolby Pro Logic II they are played as stereo signals.
Various parameters can be set according to the type
of source and the contents, so it is possible to achieve
optimum decoding.
SURROUND MODE
eld
with a “three dimensional” feel, giving the sense of
distance, movement and relative position and creating
a surprisingly real and powerful sense of presence
when playing movie software in AV rooms.
Press to select between various Pro Logic II, DTS
Neo: 6 effects for matrix encoded analogue or digital
material or for post-processing DD/DTS material
Note:
TI 1000 HC is unable to auto-detect this kind
of source material as it does not include embedded
ags so manual selection is required.
Also selects various DSP created surround sound
modes for uncoded stereo sources.
RESET
When this unit is ON, press down TUNER and
BLUETOOTH buttons on the front panel at the
same time for more than 3 seconds to reset the whole
system (including memories).
PHONES jack
For private listening, insert optional (not included)
headphones (1/4-inch plug) into the PHONES jack,
and then the center and surround speaker will be cut
automatically.
Note:
When the headphone is used, the output will
down mix to STEREO automatically.
BASS/TREBLE Control
BASS control is used to adjust the level of the low
frequency sound range.
TREBLE control is used to adjust the level of high
frequency sound range.
Press one of them on the remote control and then
press Vol+/- key to adjust the level of them.
