18
Turn it back on
BASIC OPERATIONS
Radio Operations
Automatic Tuning
1. Press the
Power On/Off
button on the front panel to
turn this unit on.
2. Press the
Tuner
button on the front panel or on the
remote control.
3. Press the
“APS”
button on remote control to
activate automatic selection. (Default mode is
Manual selection). (
Note:
SEARCHING appears
on the display).
4. Press
and
TUNING -
to select the
station you want to listen to. When a station is
tuned in, the tuning process will stop automatically.
(Automatic selection).
5. Press
or
TUNING -
again to select
another channel.
Manual Tuning
It is for selecting stations, which cannot be tuned
automatically. (Manual selection).
To tune a channel manually:
Skip step 3 in the above procedures. Each time the
or
TUNING-
button is pressed momentarily
step: FM: 50 kHz steps; MW: 9 kHz steps.
Two FM modes available:
Press
STEREO
or
MONO
button on remote control to
select Stereo mode or Mono mode.
Stereo
FM stereo broadcasts are received in stereo and the
“
ST
” indicator lights on the display.
Mono
To compensate for weak FM stereo reception, select
this mode. Reception will now be forced monaural,
reducing unwanted noise.
If
DISPLAY
button is pressed, the details of incoming
source will be displayed.
Preset Tuning
This facility is used to store FM broadcasting from
channel 1 to 20 respectively.
How to select preset stations
Press the “ ” “ ” on remote
control to select a preset channel during the tuner
mode.
Manual Memory Presetting
1. Press the Tuner button on the front panel or on the
remote control.
2. Press the
or
TUNING -
buttons to select
a frequency channel you want to preset.
3. Press the
MEMORY
4.
The station number will be displayed on the screen.
5. Press the
MEMORY
more stations, repeat steps 2 to 6.
