20
Turn it back on
OSD MENU
Setup
The setup of TI1000 HC is a reasonably simple 4
stage process. The speaker setup process (stage 2.)
can either be performed manually or via Microphone
procedure.
The procedure is as follows:
guration.
2. Speaker setup (Speaker delay and Level calibra-
tion).
3. Assigning any HDMI sources.
4. Source setup (Audio type and Video type for each
source).
guration
Auto speaker set up using microphone
TI 1000 HC includes our simple automatic speaker
setup system. The system performs two sets of tests
whether they are wired correctly and in phase, then
automatically measuring and adjusting the speaker
delay timings (i.e. distance setting) and levels.
Before activating this feature the
‘Decode Mode’
of
TI 1000 HC and Large/Small/None status of each
speaker must be set correctly as explained on page
22.
This is important as the unit will only look for and
check the speakers you have told it you have.
supplied microphone to the line in input on the front
panel and place it at your normal listening position in
the room.
Press the OSD button on the remote control to access
the OSD and then select the Speaker Setup Menu.
Now select the option ‘
Auto Setup’.
This will access
the ‘Auto Setup Menu’ as opposite.
Follow the on-screen instructions and press ‘Enter’ on
the remote control when ready to start the Auto Setup
function.
Once activated the OSD will display the message be-
low and the word ‘
AUTOSETUP’
will also be displayed
A series of test signals will now be output from all
of the connected speaker terminals of TI 1000 HC
(including the Subwoofer output).
the one below reporting which speakers were found
and any that appear out of phase.
If any speakers appear unconnected or out of phase
carefully check the connections on the speaker and
the back of the unit. Also check any bi-wiring links that
might be present on the speaker. For any out of phase
speakers check that the re (positive) terminal
of TI 1000 HC goes to the + (positive) terminal of that
speaker and similarly the - (negative) terminal of TI
1000 HC goes to the - (negative) terminal the speaker
for that channel.
