15
Turn it back on
FM tuning
The TI420 DAB offers both manual and automatic tuning on the FM band. This makes it possible to save just one
specifi c channel. It also makes it possible to adjust the supplied antenna for the best possible signal.
Automatic tuning
1. To use the Autotune function through the front
panel controls, you must press the Autotune button.
The unit will search for a higher frequency with a
proper signal. Press and hold the Autotune button
for two seconds, the unit will search for a lower
frequency with a proper signal.
2. You can also activate the Autotune function by using the remote control.
On the display you can see that the frequency increases or decreases. When the tuner has found a channel, the
tunning process will automatically stop, and the sound from the found channel will play.
If no channels are found, you must check if the antenna has been correctly connected an adjusted.
DAB/FM TUNER
Note: If there are channels from FM band that have not been saved, you must tune into them again either
manually or automatically, if you wish to listen to them again.
2
1
Manual Tuning
1. To activate the manual tuning function through the
front panel controls, simply turn the Control/Tuning
button. If you turn it clockwise, the unit will tune in
to a station at a higher frequency and if you turn
the button anticlockwise, the unit will tune in to a
station at a lower frequency. It is also possible to
activate the manual tuning function with the remote control.
2. Use the << or >> buttons this works in the same manner as the Control/Tuning button on the
front panel.
Reset
This tuner can be reset. This is used to delete all channels stored in the unit. Press and hold Info button for two
seconds. Press the Info button once again until the display shows the message System Reset, then press Select.
All stored channels have now been removed from the unit.
1
2
