•
Optical mode
1. Whilst the TI435 is turned off, connect an
optical cable to the optical in port at the rear of
the amp and connect the other end of the
cable to a source with an optical output.
2. Turn on your amp and press the mode button
on either the amp itself or the remote control
until Optical mode is selected. The amp will
respond by saying “Optical mode.”
3. You can now play music to the amp via your
source.
•
Phono mode
1. Whilst the Amp is turned off, connect an RCA
cable to the Phono in port at the rear of the
Amp and connect the other end of the cable to
a source with a Phono output such as a
turntable.
2. Turn on your Amp and press the mode button
on either the Amp or the remote control until
Amp replies saying “Phono mode.”
3. You can now play music to the Amp via your
source. E.g. turntable.
Note:
The RCA Phono input is NOT a Phono pre-
amp phase for a turntable. So if you connect your
turntable to the Amp, make sure your turntable is
set to Line instead of Phono.
Summary of Contents for TI435 AMP
Page 1: ...TI435 AMP User Manual ...
