Synergy Controller Technical Manual, Revision H
Page 220
UUT Module Sensor
When the UUT Module is selected, you can then
select which UUT module (second column), and
then the specific sensor on that module (third
column).
Press the
Accept
button when finished.
The Sensor Select Number Code will appear in
the Settings screen shown on the previous page.
This code is derived from the UUT Module
Sensor Code Chart shown below.
Important:
To use the UUT Module Sensor for cascade control, you must have the UUTs enabled. To enable UUTs, go
to the
Comm\RS-485
folder, and change the RS-485 Mode from User Comms to UUT Sensors. You must
also set the Number of UUTs to the appropriate setting.
UUT Module Sensor Code Chart
The Synergy Controller can accommodate up to four UUT modules, with up to sixteen sensors on each
module.
UUT 1
UUT 2
UUT 3
UUT 4
UUT 5
UUT 6
UUT 7
UUT 8
Sensor 1
211
221
231
241
251
261
271
281
Sensor 2
212
222
232
242
252
262
272
282
Sensor 3
213
223
233
243
253
263
273
283
Sensor 4
214
224
234
244
254
264
274
284
Sensor 5
215
225
235
245
255
265
275
285
Sensor 6
216
226
236
246
256
266
276
286
Sensor 7
217
227
237
247
257
267
277
287
Sensor 8
218
228
238
248
258
268
278
288
Note:
Since UUT modules have 16 sensors they respond to two sequential addresses. For example, a 16
Channel UUT module configured with an address of 1 will respond as UUT 1 and UUT 2. Sensors 1 thru 8
on the module will be reported as UUT 1, Sensors 1 thru 8. Sensors 9 to 16 on the module will be reported
as UUT 2, Sensors 1 thru 8.
Summary of Contents for Synergy Compact
