background image

E1447; 

061417

TIE DOWN ENGINEERING • Atlanta, GA 30336

www.tiedown.com  (404) 344-0000 

Roof Zone Cart

Assembly Instructions

Model 65028B

Important – Please Read These Instructions Fully Before Starting Assembly

If you need have damaged or missing parts, call the Customer Service: 404-344-0000

•  Check you have all the components listed on pages 2.
•  Remove all parts from the plastic bags and separate them into their groups.
•  Keep children and animals away from the work area, small parts could choke if swallowed.
•  Make sure you have enough space to layout the parts before starting.
•  Assemble on a hard level surface.
•  Assembly of the axles/frame will be easier with 2 people.

Instruction Sheet

#08262

Page 1 of 4

TM

TM

Summary of Contents for Roof Zone Penetrator

Page 1: ...l the Customer Service 404 344 0000 Check you have all the components listed on pages 2 Remove all parts from the plastic bags and separate them into their groups Keep children and animals away from the work area small parts could choke if swallowed Make sure you have enough space to layout the parts before starting Assemble on a hard level surface Assembly of the axles frame will be easier with 2...

Page 2: ...10691 Cotter Key 3 16 x 2 6 9 10461 Bolt 1 4 20 x 2 75 Zinc 4 10 10027 Nylock Nut 1 4 20 4 11 10028 Washer 1 4 8 12 10628 Nylock Nut 5 8 11 zinc Grade 2 3 13 10513Z Flat Washer 5 8 Zinc 3 14 10455 Carriage Bolt 5 8x11 x 5 2 15 70509 Pull Pin 5 8 x 3 1 16 65027 3 3 Bushing Cart Handle 2 17 65018 4 2Z Handle Pin 1 1 18 10456 Carriage Bolt 5 8 11 x 6 1 If you need have damaged or missing parts call t...

Page 3: ... and back of the cart The axle frames will stand on their own Step 3 Lift the rear cart frame may require two people Align the mounting holes with the axle and cart frame Insert carriage bolts threw cart frame and axle frame attach with washers and nylock nuts Use a 15 16 socket wrench to tighten the nuts bolts Step 4 Lift the front cart frame may require two people Align the center mounting hole ...

Page 4: ...nside round hole Install and split open cotter key on ONE end of the handle pin 17 slide on ONE washer Insert the handle pin through the handle guide bracket on the front axle Slide one bushing over the handle pin Position the handle assembly so the wheel brake bar is located on the bottom of the handle Align the handle assembly with the handle pin bushing Slide the handle pin with bushing through...

Reviews: