404-344-0000 • www.tiedown.com
605 Stonehill Drive SW, Atlanta, GA 30336
roofing@tiedown.com
Ladder Stabilizer & Stand-off
Assembly Diagram
Part #48589
A
G
G
F
C
C
B
C
C
C
D
E
D
D
E
E
D
E
D
E
D
E
C
B
A
WARNING
• Never exceed maximum intended load of ladder
• Ladder side rails must extend at least 3 ft. above upper landing surface
• Never stand on rung above The Ladder Stabilizer
• Never stand on or use the tie bar to hold weight
• Use extreme caution and maintain balance when using Ladder Stabilizer
• Never use The Ladder Stabilizer if damaged or missing fasteners
• Always make sure that Ladder Stabilizer is secured with tethering pins prior to each use
• Never overstretch, keep waist within the ladder rails
• Stay 14 feet away from energized power lines
# Parts
Qty.
A
Left and Right Side Rail
2
B
Lower and Upper Step Bracket w/Pins
2
C
1/4”-20 x 1.75” Carriage Bolts
10
D
Washer 1/4”
10
E
Nylon Nut
10
# Parts
Qty.
F
Tie Bar
1
G
Non-Marring Bumper Feet
2
Slide the Ladder Stabilizer step
brackets over the ladder rung until
they are in contact with the rung.
Slide tethering pins through the
step bracket holes making sure
that they also go through the hole
in the back of the step bracket.
