Section 23: Profile Editor
T
ieline
T E C H N O L O G Y
Page 199
XLRs),
HP 1 Left
&
Right
and
PPM 2
. This program matrix is also used for the
ManDflt Mono/IFB
profile
.
23.9.
Manual Default Mono/IFB
This profile uses the same
Manual Default Program B
matrix as the previous
profile for routing program signals. In addition it allows IFB communications.
The following image displays the IFB settings for this profile when viewing the
default
Cue/Comms
and
Phone Cue
matrices.
Figure 61: Manual Default Mono/IFB Matrix Settings
The
Cue/Comms
matrix settings are set for
Inputs 1 & 2
to be sent to
Encoder 2
and to the right side of the headphone output.
The
Aux
input is being sent to the right side of
HP 1
but not to the
Encoder,
so
Cue/Comms
on this input can be used as a cue or pre-fade listen for a program
audio source such as music or sound effects. The
Phone
input’s audio is being
monitored in the right side of HP 1.
Phone
Out
audio is being sent from the
Input 1
audio source.
Via
Decoder 1
, the incoming mix minus audio feed is being monitored in the left
side of each
HP
output and is also being sent to
CH 1 & 2 Out
. All four wired
audio inputs are being monitored via
PPM 2
.
This would be an ideal setup for commentators’ microphones which can send
outbound talkback signals via
Encoder 2
from a broadcast site and at the same
time receive talkback communications from the studio rack mount codec as
shown. At the remote venue, each commentator (on a field unit codec) could also
