Appendix 2: Connecting the Front Panel to the 1RU Codec
T
ieline
T E C H N O L O G Y
Page 370
Place the washer onto the shaft where the Menu Selector will be attached. Finger-
tighten the nut onto the Menu Selector shaft, then use the adjustable wrench to
tighten the nut as displayed. Use caution as before with all hand tools to prevent
damage to the panel.
Step 16.
Slide the Menu Selector
knob onto its shaft and
ensure that there is a gap
of approximately 1.8 mm
between the front panel
and the lower section of
the Menu Selector knob.
Lightly tighten the grub
screw with the Allen key.
Test the gap by pressing
the knob down at the edge
of the knob. It will click if correct. If not,
increase the
gap slightly.
The 1.8 mm gap
between the front
panel and the Menu
Selector knob.
