Introduction
3
Before using the Handyscope TP450 first read chapter
about safety.
Many technicians investigate electrical signals.
Though the
measurement may not be electrical, the physical variable is of-
ten converted to an electrical signal, with a special transducer.
Common transducers are accelerometers, pressure probes, current
clamps and temperature probes. The advantages of converting the
physical parameters to electrical signals are large, since many in-
struments for examining electrical signals are available.
The Handyscope TP450 is a single channel, 16 bits measuring
instrument with galvanically isolated differential input with high
input range. It is available in two models with different maximum
sampling and streaming rates:
Maximum sampling rate
Model 250
Model 50
Block mode
250 kS/s
50 kS/s
Streaming mode
250 kS/s
50 kS/s
Table 3.1: Maximum sampling rates
The Handyscope TP450 is available with two memory configura-
tions, these are:
Memory
Model 250
Model 50
Standard model
16 KiS
16 KiS
Option XM
1 MiS
1 MiS
Table 3.2: Maximum record length per channel
With the accompanying software the Handyscope TP450 can be
used as an oscilloscope, a spectrum analyzer, a true RMS voltmeter
or a transient recorder. All instruments measure by sampling the
input signals, digitizing the values, process them, save them and
display them.
Introduction
5
Summary of Contents for Handyscope TP450
