Safety
When working with electricity, no instrument can guaran-
tee complete safety. It is the responsibility of the person
who works with the instrument to operate it in a safe way.
Maximum security is achieved by selecting the proper in-
struments and following safe working procedures.
Safe
working tips are given below:
•
Always work according (local) regulations.
•
Work on installations with voltages higher than 25 V AC or
60 V DC should only be performed by qualified personnel.
•
Avoid working alone.
•
Observe all indications on the Current Clamp TP-CC400 be-
fore connecting any wiring
•
The Current Clamp TP-CC400 complies with class II, over-
voltage CAT II - 600 V of the EN 61010-1 and EN 61010-2-032
standards. Do not clamp around conductors with voltages
equal to or exceeding 300 V DC or 240 Vrms AC.
•
To avoid physical injury, measurements on bare conductors
or conductors with damaged insulation are not allowed
•
Check the Current Clamp TP-CC400 and test leads for dam-
ages. Do
not
use them if they are damaged
•
Take care when measuring at voltages higher than 25V AC
or 60 V DC.
•
Do not operate the equipment in an explosive atmosphere or
in the presence of flammable gases or fumes.
•
The Current Clamp TP-CC400 is designed for indoor use
only
•
Do not use the Current Clamp TP-CC400 if it does not op-
erate properly. Have the equipment inspected by qualified
service personal. If necessary, return the Current Clamp TP-
CC400 to TiePie engineering for service and repair to ensure
that safety features are maintained.
•
If the Current Clamp TP-CC400 is used in a manner not
specified, the protection provided by the instrument may be
impaired.
2
Current Clamp TP-CC400
