Using the Front Panel
01-0868-401B 12/02
17
Leaving a Parameter
If you have not pressed the Enter button, you can leave a
parameter without modifying it by pressing either the:
■
Previous button which returns you to the previous menu level
■
Next button which advances you to the next parameter in the list
In either situation, the TDR60 will ignore any values entered and return the
parameter to its original setting.
After Pressing the Enter Button
If you accidentally issue an incorrect parameter
value to the TDR60, you can correct the error by:
1. Selecting the parameter again using the Selection buttons. The parameter will
begin to flash.
2. Change the parameter option to the correct value.
3. Issue the parameter again by pressing the Enter button
Example
The following example describes how to move through menus and select options.
In this example, the RF frequency will be changed.
1. From the main menu select Input.
2. The Input menu displays. Select the Config option.
3. The Input Configuration menu displays showing the first option and it’s
current parameter setting.
4. Press Next to display the next parameter: RF Freq = 11774 Mhz.
5. Using the keypad, enter the new satellite downlink frequency in MHz, then
press the Enter button. When the parameter stops flashing, the TDR60 has set
the new parameter.
MPEG2 Receiver/Decoder
Input
Service
Faults
→
Input Menu
Config
Status
Input Configuration Menu
Input Type =
Demod
→
Input Configuration Menu
RF Freq =
11774 Mhz
→
