![background image](http://html1.mh-extra.com/html/tiernan/tdr7/tdr7_manual_1114564142.webp)
Chapter 5
130
Configuring the TDR7
In all of the steps below, the RCD displays the system prompt to
indicate that the
TDR7 has set the parameter and is ready for the next
command.
To set the RF frequency:
At the RCD prompt, type
QD_RF_13225
, then press the
Enter
key.
To set the LO frequency:
At the RCD prompt, type
QD_LO_11300
, then press the
Enter
key.
To set the transport stream data rate:
At the RCD prompt, type
QD_DR_7000000
, then press the
Enter
key.
To set the Viterbi code rate:
At the RCD prompt, type
QD_CR_7 / 8
, then press the
Enter
key.
To set the incoming signal polarization:
At the RCD prompt, type
QD_LNB_VERT
, then press the
Enter
key.
After you have set the incoming signal polarization, you should verify
your entries.
Configuring the Demodulator
(Cont.)
Summary of Contents for TDR7
