Tiernan TE3000 Installation And Operation Manual Download

Page: 46 / 114

Using the Front Panel

Message PID

query-only; displays the PID for the program map
table (PMT)

—

Config>CA>IRD Cfg — The IRD Configuration menu allows you to create and modifying a list of authorized decoders, as well as enable and disable
individual IRDs for conditional access. For additional information on adding, deleting and authorizing decoders, refer to the section on TE3000 procedures
found in this chapter.

New

Adds a decoder to the conditional access
database.
Note: Non-Tiernan IRDs cannot be added to the
decoder database.

To determine the decoder’s MAC address, refer to the appropriate Tiernan
user guide which accompanied that product.

List

displays a list of all Tiernan decoders registered in
the database; used to enable and disable individual
IRDs for conditional access.

displays a list of decoders and their MAC addresses
To enable and disable an IRD, use the minus key on the alphanumeric keypad
to toggle between the On (enable) and Off (disable) parameters for the
selected IRD.

Delete

Deletes a Tiernan decoder from the conditional
access database.

displays a list of decoders and their MAC addresses

Control Menu — The Control menu allows you to control the TE3000 hardware. The Control submenus are Reset, Clock, Display, and FPLock.

Control>Reset — Used to reset the TE3000 to the last-saved configuration set. When a reset is performed, the TE3000 reloads all programmable logic
and firmware, restarts the unit, and clears the fault history log.

press Enter to reset

resets the TE3000 to the last configuration set;
reloads all programmable logic and firmware;
restarts the unit; and clears the fault history log
Additional Information: As an aid to
troubleshooting, the fault history log should be
reviewed and recorded before resetting or turning
the TE3000 power off.

returns to SD Encoder main menu after reset

Control>Clock — Used to set the date and time

Date

sets the date
If the date is entered incorrectly, or an out-of-range
value is entered, the TE3000 will display and
continue to use the previously set date.

mm/dd/yyyy
default: 00.00.0000

Time

sets the time
The hours are in a 24-hour format and must be set
from 00 to 23, where 00 is midnight and 23 is 11
PM. Both minutes and seconds can be set from 00
to 59.

hh.mm.ss
default: 00:00:00

Control>Display — Used to set the screen saver mode

ScreenSaver

this option is not available at this time

—

Control>FP Lock

State

sets the state of the front panel

locked – disables the front panel; the front panel can only be used to view
status and configuration parameters

unlocked – the front panel is unlocked and can be used to enter and
change configuration parameters (default)

Password

unlocks the front panel; used in conjunction with the
state command; password is only displayed when
the front panel is set to locked

7384 (default)
Note: ensure that the front panel displays 7384, not alphabetic characters
when using the default password to unlock the front panel

Config>Comm — The Communications menu is used to set remote control and network features; submenus include Serial and Network.

TE3000 Front Panel Menu Descriptions (continued)

Front Panel

Command

Function

Options/Response Format