66
Configuring the TE3000
!
Pixel and line sample resolution : 720 x 576 resolution video (full resolution
video)
!
Output compressed video bit rate: auto-rate calculation
Aux data parameters
!
Aux data channel inputs: Aux data channel A disabled; Auxdata channel B
disabled
Multiplexer Transport Stream Parameters
!
SCPC Operation: ASI output at 8.448 MHz
PSI tables
!
Minimal complete set
Steps 2 and 3:
After comparing these operational requirements against the
TE3000 DVB parameters, it is determined that all the parameters required to set
the audio and video encoders to the basic DSNG setup are DVB settings, with the
exception of the Audio B channel.
Step 4:
The Audio B channel must be set to Off. The front panel menus used to
change this parameter are:
Service>Audio>Analog>AudioB>Enable = Off
Step 5:
To configure the TE3000 for this example, you must first initialize the
unit to DVB default settings. The steps to perform this initialization are presented
in the previous section.
Step 6:
Once the TE3000 is set to the DVB default settings, the Audi oB
channel parameter must be changed to Off.
1. From the SD Encoder main menu select Config.
2. The Configuration menu displays. Use the right arrow to select Service and
press Enter.
3. The Service menu displays. Use the right button to select Audio and press
Enter.
SD Encoder
[ Config ]
Status
→
Configuration Menu
[ Service ]
Tx Strm
→
Service Menu
Video
[ Audio ]
Summary of Contents for TE3000
