8
Getting Started
Prepare the stand and docking bracket
Set up the stand and docking bracket:
Prepare the sled for the camera
• Set up your stand at about chest
height.
• Use one or more sandbags to
stabilize the stand.
• Put the docking bracket on the
stand and tighten the docking
bracket locking knob.
• Push the button at the end of the
aircraft pin and pull the aircraft pin
out of the yoke.
Adjust the monitor position:
• Set the monitor bracket horizontal
• Tilt the monitor to about 45
degrees.
• If the gimbal is not already near
the top of the center post, move it
there.
• Insert the T-handle Allen wrench
into the locking Allen bolt on the
gimbal.
• Loosen the bolt.
• Slide the gimbal to the top of the
center post, but always leave
enough space between the gimbal
and the stage to accommodate the
docking yoke (about 1 inch/25mm).