TIFFIN MOTORHOMES
–ALLEGRO BUS®
Chapter 9
EXTERIOR FEATURES
9-4
HWH Leveling Control Panel
The HWH Computerized Leveling system (Figure 9-5) requires
minimal effort from the motor-home user.
For leveling of the motor home, perform the following steps:
Manual Leveling (Standard):
1. Turn the ignition switch to the “acc” or “on” position. The engine
must be “off” to level the coach. The transmission shift must be in
position for parking. The park brake must be set either manually
or automatically. If the “not in park/brake” light is “on,” check or
recheck the shift and brake position.
2. Press the “hyd” button. The “hydraulic operation” indicator light
will turn “on” with a steady glow.
3. On the right-hand portion of the HWH Leveling Control touch panel, note the outline of the motor home and the
various “raise” (i.e., “up” arrow and “lower” (i.e., “down” arrow) touch buttons.
4. Press the respective “raise” (“up” arrow) button to raise the respective side or end of the motor home.
A yellow light to the front, side, or rear of the motor-home outline indicates that that side or end is low.
The “lower” (“down” arrow) buttons will lower the motor home.
Automatic Leveling
1. Turn the ignition switch to the “acc” or “on” position. The engine must be “off” to level the coach. The transmission
shift must be in position for parking. The park brake must be set either manually or automatically. If the “not in
park/brake” light is “on,” check or recheck the shift and brake position.
2. Press the “hyd” button once—the motor home will automatically level itself.
NOTE: The hydraulic jacks will always work in pairs: Front end, right side, left side, or rear end. During
transit of the motor home, the “Store” position on the HWH Leveling Console must be engaged.
Leveling System (Air)
The Allegro Bus may be equipped with an optional air leveling system. Before engaging the air leveling system, ensure
that the following are in place: the vehicle’s engine is running and the air system is at full pressure; the parking brake is
engaged; and the front wheels are straightened. If the
POWER
indicator is flashing, the ignition is off, and must be
turned on. Also verify that the standard hydraulic leveling system is not selected, then press
AUTO
.
Figure 9-5. HWH Computerized Leveling System
Summary of Contents for 2014 Allegro Bus
