6. MAKING FINAL ADJUSTMENTS
5. SETTING TABLE UPRIGHT
16. Before lifting table, be sure both top halves are
locked in safety latches! Be sure casters are locked!
Put a 7 inch stack of magazines, wood, etc. under caster
beam nearest the floor to protect casters.
(See Detail
K
).
17. With the help of one other adult,
brace lower caster
beam with your foot and lift table upright. (See Detail
L
).
18.
Once upright, release safety latch and lower table top
halves. (See Detail
M
and
OPERATING INSTRUCTIONS
on next page).
At least two adults are needed to complete the following
steps. Be sure top halves are locked in safety latches! Be sure
that both locking casters are locked!
You must use a 7" stack of magazines (or similar block) to
protect the casters when lifting table upright!
CAUTION
19.
Loosen the six bolts shown
below and adjust table so
that the space between the
two table top halves
measures 5/16 of an inch.
20.
Retighten these bolts.
21.
Check over entire assembly
to be sure all nuts and bolts
are secure.
Remember, do
not overtighten bolts at
joints that move.
6
If your gap between table halves is greater than 5/16" or uneven adjust it as follows.
