OPERATING INSTRUCTIONS
CAUTION
n
n
n
n
n
ALWAYS LOCK TABLE TOP HALVES IN SAFETY LATCHES WHEN STORING,
MOVING, OR USING TABLE IN ITS PLAYBACK POSITION!
n
n
n
n
n
ALWAYS LOCK CASTERS, EXCEPT WHEN MOVING TABLE!
n
n
n
n
n
DO NOT SIT, STAND, WALK OR JUMP ON THIS TABLE!
To open table:
1.
Lock both locking casters.
2.
Release safety latch and pull table top
outward and downward. Be ready to support
weight of table top.
Table top is heavy
3.
Lower table top half.
To close table:
1.
Lock both locking casters.
2.
Lift table top half.
3.
Check that top is locked in safety latches.
7
Ne
t System Description
1. Net Post Assembly
Attach plastic net post as shown with washer and knob.
Note: there is a left and right net post assembly (See Net
System Description). Post assembly should rest flat
against nut plate. Slide the net sleeve over the vertical
post while the net post assembly is folded in toward the
side of the table top. Fold the net post assembly out
against the net post stop into the post and secure bead
chain in catch.
2. Adjustments
A - Adjust overall net tension by slightly loosening
the knob and moving net post assembly. Moder-
ately tighten knob. Net post assembly should be
kept square with the table by the net post stop (See
Net System Description).
B - Adjust tension of cord with bead chain on each
side. Assure that chain is fully seated in catch.
C - Position top of net to a regulation height of 6”
from the table surface by firmly gripping the verti-
cal net post within height adjustment slot.
3. Storage
Caution: To prevent damage to the net system and/or table top, the post assembly must be pivoted toward side of table before lifting table tops to storage position.
Loosen knob and pivot net post toward table side as far as it will go. Retighten Knob.