Edition
Manual
Chapter
Page
2008-10-17 Workshop Manual, Stiga Titan 6 Control wires
7
2. Loosen the wire attachment screw and
release the wire ends.
3. Loosen the adjustment sleeve nuts and
release the wire conduits.
4. Loosen the wires under the machine by
unscrewing the adjustment sleeve nuts and
unhook from the springs.
6.3.3 Inspections
• Check that the wire can be easily moved in its
conduit during the entire stroke.
• Check that the conduit is free from sharp
bends and other damages. The conduit outer
cover must be intact to prevent water to enter
the wire.
• Check that the conduit end sealings are
intact.
6.3.4 Assembly
1. Lubricate the wire through its end sealings.
Use machine oil. Slide the wire between its
end positions until the oil has reached the
entire wire.
2. Fit the wire to the machine as observed dur-
ing the disassembly. See also the figure.
3. Adjust the wire. See below.
x2
