Refer to the drawings on the following pages to familiarize yourself with the SmartJet
®
system menus for your spa. Please note that the SmartJet
system lever side of the spa is always considered the front when referring to the locations of the different types of jets and jet systems. The clock
positions are correct when facing the spa, standing at the SmartJet
system lever.
115 vOLT gFCI
The Ground Fault Circuit Interrupter is a safety device that is designed to detect as little as 5 milliamps (±1mA) of electrical current
leakage to ground. Watkins Manufacturing Corporation recommends that the GFCI be tested prior to each use to ensure that it is
functioning correctly. With the spa connected to the power supply, push the TEST button. The spa should stop operating and the
GFCI power indicator will go out. Wait 30 seconds and then reset the GFCI by pushing the RESET button. The GFCI power indicator
will turn on, restoring power to the spa. If the interrupter does not perform in this manner, it is an indication of an electrical malfunction
and the possibility of an electric shock. Disconnect the plug from the receptacle until the fault has been identified and corrected.
NOTE:
Failure to wait 30 seconds before resetting the GFCI may cause the spa’s Power indicator (on the control panel) to blink.
If this occurs, repeat the GFCI test procedure.
CAUTION:
Never use the GFCI as a means to disconnect power to the spa (always unplug it). If the GFCI is tripped while the spa is plugged in,
and a power outage occurs, when power returns the GFCI will automatically reset and power will flow to the spa.
WATER FEATURE
(available on the Caspian
™
& bengal (MM)
®
models only)
The Caspian and Bengal (MM) come equipped with the Amur
®
water feature. This water feature can be turned on or off when the two-speed pump
is on low speed (tranquil mode) or high speed. To function correctly, the water feature on/off lever must be placed in the
full
on position only.
If the lever is not in the full on position when the pump is on high speed, it is likely that the water feature will project water substantially farther out
into the spa as the on/off lever is opened. This is not proper operation. If this occurs, the pump should be turned off, the water feature lever rotated
to the full on position and the pump turned on again.
When not in use turn the on/off lever to the OFF position.
CAUTION
: Partial blockage of water flow at entrance of water feature will cause the water to flow farther into or over the spa.
page 21
Operating Instructions
Summary of Contents for Bengal
Page 1: ......
