Tiger Box 3U16 Assembly Guide
Post Installation Maintenance:
16
Post Installation Maintenance
Cleaning the Bezel Filter
The front panel bezel features an advanced protection filter that prevents dust from
accumulating in the RAID drives and the enclosure. It is advisable to clean the bezel
filter every 3 months.
To clean the bezel filter:
1.
Remove the bezel (see steps on page 7).
The filter is snapped on the inside frame of the bezel.
2.
Take the filter off by hand and wash it under running water, then leave it to dry.
3.
When the filter is completely dry, fit it inside the bezel by snapping its magnetic
strips to the inside frame of the bezel.
4.
Install the bezel (see steps on page 8).
Replacing a Failed Drive
You can replace a failed hard disk, while Tiger Box 3U16 is operating and no data on
the storage will be lost. If your order includes a spare drive, it is shipped to you pre-
installed in a drive carrier and is ready to replace the one that has failed.
You can also replace a failed drive with a drive not included in your shipment. In this
case the new drive must be exactly the same size and make as the one that has failed.
Additionally, you should uninstall the failed drive from its drive carrier and then
install the replacement drive in the carrier.
Important:
Periodically check the RAID status in the Storage page of Tiger
Store’s web UI. Degraded RAID status indicates that a drive has failed and
needs to be replaced. If more than one RAID drive fails, the RAID will become
inaccessible and data loss is possible.
