Have What It Takes
1.800.661.4661
View demonstration videos and a
complete product list at
tigertool.com
Technical Support
Operating Instructions
Bushing Installation
1
Thread on the 15001-55 cylinder adapter to the 17202
hydraulic cylinder.
2
Attach the 15001-79 face plate to the 15001-55
cylinder adapter (the 15001-57 extension tube is
not used for installation).
3
Place the 15001-112 push adapter on to the new bushing
and install one of the 15001-125 threaded pins, tighten by
hand with the provided ¼" socket driver.
4
Insert the 15001-3 pull-bar through the 15001-126 pull
adapter. Place the pull adapter/pull-bar over the other
end of the bushing and install the remaining 15001-125
threaded pin.
5
Insert the pull-bar and bushing assembly through the eye
of the torque rod (threaded end of the pull-bar first) until
the bushing is up against the torque rod in the desired
orientation.
6
Place the hydraulic cylinder, cylinder adapter, face plate
over the pull-bar and thread on the 15001-7 trigon nut,
hand tighten.
7
Connect your 10,000psi hydraulic pump to the cylinder and
apply force until the cylinder has fully extended. Release
pressure and hand tighten trigon nut. Repeat until the
bushing is in desired installed depth.
8
Remove adapters from the bushing and
disassemble tooling.
Here at Tiger Tool, your satisfaction is our number one
priority. Should you have any questions about this or any of
our products, please call us at 1.800.661.4661.
Peterbilt Air Trac Pin
& Bushing Adapter
15012
