Tiger ADS-A02U, Instruction Manual

12

Making Coffee

Remove the cylinder unit from the main unit.

‘

Removing the cylinder unit 

→

 P. 10

1

Remove the upper cylinder and lower cylinder 

from the joint.

‘

Be sure to hold the joint when turning the cylinders.

2

Use the provided measuring spoon to add coffee 

grounds on top of the filter and smooth out the top.

‘

Because the bottom of the lower cylinder is unstable, place it into the provided cylinder stand.

3

<Guidelines for adding coffee grounds>

Amount extracted

Coffee grounds

(level measuring spoons)

Water level scale

240 mL

Two spoonfuls

120 mL

One spoonful

120 mL(for iced coffee)

Two spoonfuls

‘

Adjust the amount of coffee grounds according to your preference.

‘

When using Dual Temp, it is recommended that you extract 240 mL.

‘

Because there is the risk of overflowing, do not add more than two 

level measuring spoons.

‘

When you will add ice to make iced coffee after extracting the coffee, it is recommended 

that you use coffee grounds that are marketed specifically for iced coffee.

Caution

y

Do not 

use superfine coffee grounds.

 Use medium-fine or larger coffee grounds. 

Superfine coffee grounds may clog the filter, preventing operation from completing normally.

Caution

y

Do not add c

offee grounds before installing the filter into the lower cylinder. 

Also do not add coffee grounds into the water pumping pipe.

 Doing so may cause 

coffee grounds to enter the main unit, preventing operation from completing normally.

y

Check that the water pumping pipe gasket is attached to the water pumping pipe. 

→ P. 10, 17

y

Check that the water pumping pipe and filter are installed in the lower cylinder.

y

Install the water pumping pipe and filter so they are straight, and make 

sure there is no gap between the lower cylinder and the filter gasket.

If there is a gap, the coffee grounds may fall through it.

Cylinder unit

Joint

Upper 

cylinder

Lower 

cylinder

(1) Turn

(3)

Turn

Cylinder 

stand

Lower 

cylinder
Water 

pumping pipe

Filter

(2) Remove

(4)

Remove

Lower 

cylinder

Make sure there is 

no gap between the 

lower cylinder and 

the filter gasket.

Filter gasket