Body
Cau
tion
Do not immerse the body and stopper when washing them. (Water may enter.)
After washing the whole body, immediately use a dry cloth to wipe off the
moisture on its outer surface. Not wiping off all droplets could leave water
stains or cause rust and other marks.
Do not use thinners, cleansers, chlorine-based bleaches, chemical wipes, metallic
scrubbing brushes, or nylon scrubbing brushes.
Do not use a dishwasher or dish dryer, and do not wash with boiling water. (Except gasket)
Be sure to attach the gaskets.
Dry the parts completely after removing stains when the product has not been
used for a long time.
Screw stopper
Gasket
(Remove and
clean)
Handle stopper
How to Clean
Clean the product on the same day after every use.
Use mild kitchen detergent (for table or cookware).
Use a soft sponge or cloth.
Clean the product thoroughly to prevent any odor.
Wash each part using a
sponge and detergent diluted
with water or lukewarm water,
and then thoroughly rinse it
with water.
Wipe the water off with a dry
cloth and dry them thoroughly.
(1)
(2)
If stains appear inside the main body
When red, rust-like spots or a substance that is rough to the touch appears
Such stains can be caused by minerals in water, such as calcium, magnesium, and iron. When
cleaning these substances, please use citric acid, which is available at supermarkets and drug stores.
1. Dilute the citric acid (approximately 10 g) with lukewarm water, then pour it into the
main body.
2. After 2 to 3 hours, wash the main body with a soft brush and then thoroughly rinse it.
3. Fully dry the main body.
When the gasket becomes stained
Depending on the beverage, the beverage color may remain on the gasket. There is no
problem in using the gasket even if it becomes stained. If you are concerned about stains,
please purchase a new gasket (sold separately).
7
Gasket
Slowly remove the
gasket while holding
and turning it.
When attaching the gasket,
make sure to fit it completely in
the proper direction.
(The product shown in the figure is MEA-B048. The gasket attachment
method is the same for MEA-A048.)
How to attach and remove the gasket
Do not attach the gasket in the incorrect place or direction.
The contents may leak.
Cau
tion
How to remove
How to attach
Depending on the beverage, the beverage odor may remain on the
gasket. In this case, leave the gasket in boiling water for approximately
30 minutes. If the odor still remains, please purchase a new gasket
(sold separately).
When an odor remains on the gasket
8
