ENGLISH – Tiki start
15
The speed of the blower adapts automatically to create a positive pressure of 0.2
mbar. Therefore, it is important that the user calibrates the blower at every use of the
Tiki start and as the user enters another space as for example: inside versus outside,
floor, operating room etc.
Refer to the procedure: 4.4 Calibrate the blower on page 31.
2.2 Buttons and indicator lights
The blower of the Tiki start and hence the Tiki start contains the following buttons,
lights and indicator lights.
The buttons can be used as the blower is positioned in the mask.
Refer to figure 11:
11a The on / off button
11b The lights to apply extra light at the work spot
11c The button for the lights at 11b
11d Three (3) indicator lights
2.2.1 The on / off button
Use the on / off button to:
■
Calibrate the blower as to the procedure: 4.4 Calibrate the blower, on page 31
■
Start and stop the blower unit.
To do so, press and hold the on / off button for 3 seconds
2.2.2 The lights
Use the lights to cast extra light on the working area.
2.2.3 The button for the lights
Use the button for the lights to:
As the blower is ‘on’, switch on or switch off the lights