8
Tiki start – ENGLISH
1.7 Material of the Tiki start
Assembly
Part name
Material
Inhalation filter (white)
Filter cover (white)
ABS
Mask
Seal collar
ThermoPlastic Elastomer (TPE)
Harness
Clip
Nylon
Mask
Mask visor small /
medium / large
PETG
Blower
Blower cover
ABS
Harness
Triglide
POM
Mask
Outlet valve seat
PETG
Mask
Outlet valve membrane
Silicone
Harness
Harness
PA, rubber
Mask
Chin protection
CR expanded
External battery
Battery clips with screws
ABS, Steel
1.7.1 Basic components
The Tiki start holds the basic components as described in paragraph:
2.1 Description on page 12.
These basic components are manufactured in the materials as indicated above.
None of these materials expose the user of the Tiki start to a health or a safety
issue.
1.7.2 Batteries
The blower with the internal battery and the external battery contain both lithium
polymer (LiPo) batteries.
Therefore, obey the following precautions:
■
Do not dispose a LiPo battery in a fire or subject it to extreme heat
■
Do not disassemble
■
Do not use a LiPo battery if it shows signs of mechanical damage or swelling
■
Do not use a LiPo battery in either heavy rain, a shower or submerse it in water
■
Immediately stop charging or disconnect battery from other appliances should
the battery go warm
■
Do not charge a LiPo battery in an ambient temperature of less than 0 °C
In the unlikely event that the battery of the blower is damaged and electrolyte seeps
out, ensure that the electrolyte does not get in contact with the eyes of the user.